Quick Answer
The channel letter bender forms the return only. The face and the back are cut on a CNC router or a laser cutter from the same vector drawing, sized to the actual base plate. The bender grooves, bends and cuts the strip to that outline, and the return is then fitted to the base by hand along the cut line. A bender does not replace a CNC router; the two machines cover different parts of the same letter.
The Split Is Simple: Returns, Faces, Backs
A channel letter is three parts. The face is the front panel that carries the light or the finish. The back is the base plate that closes the letter. The return is the side wall that connects the two. The NF-P produces only the return, which is exactly the wall that travels around the outline. Face and back stay on the router or the laser, where flat sheet is cut and engraved. Getting this boundary straight before quoting is what prevents the most common expectation error: a shop buys a bender expecting the whole letter to come off one machine.
One Drawing, Two Machines
Start from one vector file. Draw the letter in CorelDRAW, cut the face and back on the CNC router or the laser at the actual base dimensions, then export the return outline as AI for the bender. Keeping a single source drawing is what keeps the return matched to the plate. Redrawing the return separately is how a wall ends up 2 mm off around the entire letter, and no amount of force calibration will fix a geometry problem.
Setting the Offset on Shared Geometry
On the bender, select offset mode, then enter the engraving blade diameter, the actual material thickness, the material height and the tooth-edge radius at @1. The insert and offset amount is calculated by the system from the blade diameter and the material thickness, so the blade size must match the cutter that is actually in the head. Set the value manually only when the job needs something different from the calculated number: a positive value expands the outline, a negative value shrinks it, and zero leaves the drawing untouched. After switching between offset and insert mode, close and reopen the software or re-import the file — otherwise the preview keeps showing the previous compensation and the operator trusts a wrong screen.
Assembly at the Bench
Once the strip is grooved, bent and cut, the return is fitted to the base plate by hand, following the cut line left by the router or the laser. That is the reason the two machines must agree on one outline: the plate provides the locator, the return provides the wall. When the fit is tight on one leg and loose on the next, the cause is usually in the parameter set rather than in the bending — check the thickness entry and the blade diameter before touching the force calibration.
FAQ
Does the bender replace a CNC router?
No. It produces returns only. Faces and backs still need flat-sheet cutting on a router or a laser, and the base plate is what the return is fitted to at assembly.
Which file format should be imported?
AI is the recommended format and DXF is also supported. Export the return outline from the same drawing used for the face and back, at the same scale.
Why does the preview not change after I alter the offset?
Because the setting needs a reload to be applied. Close and reopen the software or re-import the file; only then does the preview show the new compensation.